Фірма PROMAS GmbH, Germany

Edge Processing Line (short line), consisting of:

Pos. 1: Vacuum Feeder

Pos. 2: Turning Device (length to cross)

Pos. 3: Edge Banding Machine make IMA
type Combima / K / || / R80 / 1075 / F / R3

Pos. 4: Turning Device (cross to length)

Pos. 5: Stacker


Edge Banding Machine make IMA type Combima / K / || / R80 / 1075 / F / R3
(formatting, edge banding with resin melt glue and edge finish working)

Technical data:
edge materials: veneer / plastic strips / reel material
min. strip length approx. 300 mm
min. strip height approx. 14 mm
max. strip thickness approx. 3 mm

min. work piece length approx. 150 mm
min. work piece thickness approx. 10 mm
max. work piece thickness approx. 45 mm

fix work piece overhang out of the chain track
each side approx. 45 mm

min. thru feed width
a) when running lengthwise (no use of the chain cams) approx. 260 mm
b) when running crosswise (chain cams must be used) approx. 320 mm

max. thru feed width approx. 2.500 mm

infinitely variable drive for thru feed speeds approx. 7 – 35 m/min.
with electro-motorized width adjustment of the movable machine support


units each side:

milling/profile milling/grooving unit, controllable
double hogger (top/bottom)
milling/profile milling/grooving unit, controllable
double roll edge magazine (for reel material up to 3 mm)
gluing part with premelt glue pot
end trimming units with 2 motors
flush milling unit (top/bottom)
fine milling unit (top/bottom)
profile milling unit (top/bottom)
contour trimming unit (from bottom) with 2 motors
contour trimming unit (from top) with 2 motors
profile scraper
buffing unit (vertical working) with 2 motors
buffing unit (horizontal working) with 2 motors


This line is still running and can be seen in operation.
Please contact us to make an appointment!